Video summary
두 업자 모두 놓친 불량? #대전컴퓨터 #컴퓨터조립 #컴퓨터견적
Main summary
Key takeaways
Tech concepts / issues discussed
-
Abnormal CPU temperatures on a newly built/serviced PC:
- Reported temps spiked to ~70–80°C even at idle / while “doing nothing,” and at times reached ~90–100°C.
- This raised concerns that the system could trigger shutdown or suffer extreme overheating.
- After temporarily swapping coolers, temps dropped to ~40–50°C at idle, suggesting the original cooling setup was the root fault.
-
Liquid cooler / performance cooler pump failure suspicion:
- The repair shop stated the symptoms are consistent with a cooler pump problem (not necessarily a leak).
- In severe pump failures, temps can hit ~100–105°C quickly after Windows boots, and the system may not power off properly while overheating.
-
BIOS-related problems affecting boot time and stability:
- The customer previously tweaked BIOS settings (described as “messing around” with BIOS/power limits).
- After formatting and further changes, there were persistent issues including very slow boot / long POST (boot) time.
- Recommended fix: reset BIOS to defaults to undo custom settings (e.g., voltage/power/limits).
- There’s also a general note that higher-end boards may take longer to boot due to extended checks, but the observed behavior was far beyond normal.
Product/service features & actions taken (repair process)
-
System overhaul attempt earlier:
- The customer had the PC serviced/overhauled because temperatures stayed high after initial troubleshooting.
- Even after redoing parts/configuration, the temperature issue persisted, implying the root cause wasn’t fully addressed.
-
Troubleshooting steps used in the video:
- Confirm/restore BIOS defaults (undo BIOS changes) to fix boot-time issues.
- Run “Real Benchmark” and observe temperatures under load.
- Temporarily install a stock air cooler to isolate whether the water/performance cooler is faulty.
- Conclude the water cooler likely has a faulty pump, then replace the cooler.
- Re-test benchmarks with the corrected cooler setup.
Findings / conclusions (what was actually wrong)
-
Two main problems identified:
- Boot issue, likely worsened by BIOS tweaks and/or power-limit/boot behavior.
- Temperature issue, diagnosed as a cooler pump / performance cooler failure.
-
After cooler replacement:
- Idle temperatures dropped to ~40–50°C.
- Load temperatures peaked in the low 80s.
- With a 3-row liquid cooler, the claim is it should max around ~80°C, consistent with expected performance.
Cost / review-like commentary mentioned
- Total cost discussed: ~6 million won (with a prior range noted as ~5–6 million won).
- Criticism/concern about both contractors:
- The video implies both the original YouTuber seller and the subsequent shop missed diagnosing the cooler correctly, especially regarding the abnormal temperature.
Tutorial / guide takeaways
-
If you experience:
- Abnormal CPU temps (especially jumping high quickly), don’t assume it’s only the CPU/GPU—test the cooler, since pump failure can present this way.
- Slow boot / instability after BIOS tweaks, try resetting BIOS to defaults before deeper hardware changes.
-
Verification method:
- Bench testing (“Real Benchmark”) is used after each significant change to confirm the fix.
Main speakers / sources
- A computer repair shop technician / YouTuber host: Primary narrator performing diagnosis, BIOS reset, benchmark tests, and cooler replacement.
- The customer: PC owner describing symptoms and prior service history.
- An unspecified YouTuber: Mentioned as the original seller/builder (name not revealed).